Ground Dogs Rollout Awning Anchor Kit Protect Your Investment: Rollout Awnings are expensive. Wind damage from inadequate Tie Downs can destroy your awning in minutes.

FEATURES AND BENEFITS:

• Extreme Hard Packed Terrain.
• Soft, muddy ground – Big Dog Screw in Pegs upgrade recommended.
• Beach Sand – Sand Dog Screw in Pegs upgrade recommended.
• No need to use Anchor Plate when on the beach.

SPECIFICATIONS:

• There are 2 ways to use your rollout awning anchor kit:

1. If standing the awning legs vertically:

• Unroll your awning.
• Lock in bracing arm.
• Adjust awning to desired height.
• Detach awning leg and stand vertically.
• Lift the leg slightly and place an anchor plate over the connector bar on the foot of the awning leg with the longer side facing away from the caravan.
• Drive a Ground Dog Screw in Peg® with Wing Collar through each hole on both sides of the awning leg stopping to allow enough room to attach the safety Spring with Tie Down Strap.
• Complete Driving in the Ground Dog Screw in Peg®.
• Connect the long piece of the Tie Down Strap to the shorter piece and tighten making sure the Safety Spring is not distorted. (If the safety spring is elongated, it has been pulled too tight)
• If standing both legs, repeat on the other end and adjust as necessary.
• In case of bad weather, a Tie Down Strap can be added for extra security.

2. If leaving the awning legs attached:

• Attach the longer piece of the tie down Strap to the Safety Spring by passing the loop end through either end of the Safety Spring then place the other end of the strap through the loop and pull through.
• Unroll your awning, before raising, attach the smaller piece of the tiedown strap to each end of the barrel by placing it around the awning barrel and pass the Cam Buckle through the loop on the other end.
• Raise the awning to the desired height.
• Position the Ground Dog Peg with Hook Collar around a metre Infront if the vertical line of the barrel.
• Drive in the Ground Dog stopping to allow enough space to attach the Safety Spring.
• Attach the Safety Spring and finish driving in the Peg.
• Attach the Strap Retaining Clip to the longer piece of strap, it will sit under the Cam Buckle once the Strap is fed through.
• Connect both pieces of the Tie Down Strap and tighten, stop when the Safety Spring starts to stretch. (do not stretch the Safety Spring out of shape). Secure the loose end of the tie down strap in the retaining clip.

WHAT IS INCLUDED:

• Ground Dogs Rollout Awning Anchor Kit
• 4 x Ground Dog Screw in Pegs with Wing Collars – 250mm For securing anchor plates.
• 2 x Ground Dog Screw in Pegs with Hook Collars – For tie down attachments.
• 2 x Rollout Awning Anchor Plates – Slides over awning leg feet.
• 2 x Tie Down Straps with Retaining Clips – High-visibility orange webbing for extra security.
• 4 x Awning Hooks – Hang items from your awning rail.
• 1 x 19mm Socket and Drill Adaptor – installation tool.
• 2 x Safety Springs – Safe alternative to sharp metal springs.
• 1 x Canvas Zip Bag – Keep everything organised.

IMPORTANT INFORMATION:

Not what you are looking for? Check out our full range of Awning Accessories here.